Warranty Information
  Warranty Claim Form 
Stud Claims
In order to properly submit a warranty claim on the Hedge Hog, Warthog XZP, Top Dog, Big Shot or Lynx studs, the following definitions must apply. If your studs are exhibiting any bending, breaking at the thread-line (or below), you may be covered under the exclusive no bend, no break guarantee. Studs Size 84 and longer will be covered only if using the Big Al aluminum support nuts. For warranty to be valid, the accu-stud chart for stud length and quantities must be used. Studs used for racing purposes will not be eligible for warranty due to the extreme conditions they are used in.

Carbide pin chipping is not covered under any warranties, and can occasionally be mistaken as carbide pin fallout. If you experienced carbide pin chippage, it will either be chipped flush or slightly below the surface of the metal tip on the stud. If the pin had fallen out, the hole will be about .300 of an inch deep and may be covered as a defect.

All other studs are covered against defects in material and workmanship. This may include carbide pin fallout, cracked heads, and bad hex stamps. This does not include bending, or breaking. Snowstuds.com remains the sole judge on any defect in workmanship claims. Also return related components such as nut and backer plate used to mount studs.
Runner Claims
All Snowstuds.com runners are also covered against defect in material and workmanship. Carbide insert chippage or bent and deformed bars caused by impacting foreign objects will not be covered under any warranty.

Warranty against carbide falling out
No part of the host bar may be less than the following to qualify for replacement:
- bar - no less than .410
- 7/16 bar - no less than .375
- 3/8 bar - no less than .300

Height measured from bottom of bar to top (where carbide is absent) - No part (or area) may be less than above measurements to qualify for replacement.
Backer Claims
In order to properly submit a warranty claim on the Macro-Lite backers, you MUST provide your proof of purchase. The Macro-Lite backer carries a warranty for one year from date of purchase. Improper installation techniques are not covered under any warranty. Torque specs must be followed. All other backers are covered against defect in materials and workmanship. Snowstuds.com remains the sole judge on any defect in workmanship claim.
Warranty Returns
Contact our support team at support@snowstuds.com, Attention: Support Team for a Return Authorization Number.

Snowstuds.com will not accept any returns without this number. The Return Authorization Number must be visible on the outside of the package. The product must be inspected by a snowstuds technician to determine if the product is defective due to materials, quality or workmanship before a final warranty determination is made.